Assignments

Assignments

There are multiple assignment operators:

Symbol

Description

:=

Standard assignment, equivalent to <= in VHDL/Verilog. The last assignment to a variable wins; the value is not updated until the next simulation delta cycle.

\=

Equivalent to := in VHDL and = in Verilog. The value is updated instantly in-place.

<>

Automatic connection between 2 signals or two bundles of the same type. Direction is inferred by using signal direction (in/out). (Similar behavior to :=)

// Because of hardware concurrency, `a` is always read as '1' by b and c
val a, b, c = UInt(4 bits)
a := 0
b := a
a := 1  // a := 1 "wins"
c := a

var x = UInt(4 bits)
val y, z = UInt(4 bits)
x := 0
y := x      // y read x with the value 0
x \= x + 1
z := x      // z read x with the value 1

// Automatic connection between two UART interfaces.
uartCtrl.io.uart <> io.uart

It is important to understand that in SpinalHDL, the nature of a signal (combinational/sequential) is defined in its declaration, not by the way it is assigned. All datatype instances will define a combinational signal, while a datatype instance wrapped with Reg(...) will define a sequential (registered) signal.

val a = UInt(4 bits) // Define a combinational signal
val b = Reg(UInt(4 bits)) // Define a registered signal
val c = Reg(UInt(4 bits)) init(0) // Define a registered signal which is set to 0 when a reset occurs

Width checking

SpinalHDL checks that the bit count of the left side and the right side of an assigmnet matches. There are multiple ways to adapt the width of a given BitVector (Bits, UInt, SInt):

Resizing techniques

Description

x := y.resized

Assign x with a resized copy of y, resize value is automatically inferred to match x

x := y.resize(newWidth)

Assign x with a resized copy of y, size is manually calculated

There is one case where Spinal automatically resizes a value:

Assignment

Problem

SpinalHDL action

myUIntOf_8bit := U(3)

U(3) creates an UInt of 2 bits, which doesn’t match the left side (8 bits)

Because U(3) is a “weak” bit count inferred signal, SpinalHDL resizes it automatically

Combinatorial loops

SpinalHDL checks that there are no combinatorial loops (latches) in your design. If one is detected, it raises an error and SpinalHDL will print the path of the loop.